Login
Sign up

Mean Well LPV-35-36 36V 35W IP67 LED Driver

Home /
Home DIY (Garden, Yard) /
LED Assemblies - Heat Sink & Lens & LED Drivers

Mean Well LPV-35-36 36V 35W IP67 LED Driver[68]

★★★★★(983 recommends)

SKUPS-SP11345

22.90

Add To Cart
Buy Now

+

Description

This Mean Well LED Driver is ideally suitable for LED lighting and moving sign applications. With constant voltage design, it is capable of delivering 35watts output. It is fully encapsulated with IP67 level. Power input is world compatible and able to work with anywhere from 100 to 240 volts AC input. Each product is 100% full load burn-in-tested and can handle up to 300VAC surge input for 5 seconds. Over load, over voltage and short circuit protection is built in to ensure its reliability.

  • TypeLED Driver
  • StyleLED Driver
  • Output ChannelSingle
  • Constant voltage design
  • Universal AC input/Full range
  • Withstand 300VAC surge input for 5 seconds
  • Protections: Short circuit / Overload / Over voltage
  • Cooling by free air convection
  • Fully encapsulated with IP67 level (Note.8)
  • Fully isolated plastic case
  • Class II power unit, no FG
  • Class 2 power unit
  • Pass LPS
  • Suitable for LED lighting and moving sign applications
  • 100% full load burn-in-test
  • Low cost, High reliability
MODELLPV-35-36
OUTPUTDC VOLTAGE36V
RATED CURRENT1A
CURRENT RANGE0 ~ 1A
RATED POWER(max.)36W
RIPPLE & NOISE(max.) (Note.2)150mVp-p
VOLTAGE TOLERANCE (Note.3)±5.0%
LINE REGULATION ±1.0%
LOAD REGULATION ±2.0%
SETUP, RISE TIME(Note.6)500ms, 20ms/230VAC 500ms, 20ms/115VAC at full load
HOLD UP TIME(Typ.)50ms/230VAC   16ms/115VAC at full load
INPUTVOLTAGE RANGE(Note.4)90 ~ 264VAC  127 ~ 370VDC
FREQUENCY RANGE47 ~ 63Hz
EFFICIENCY(Typ.)85%
AC CURRENT(Typ.)1.1A/115VAC    0.7A/230VAC
INRUSH CURRENT(Typ.)COLD START 55A(twidth=510μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER4 units(circuit breaker of type B)/ 7 units(circuit breaker of type C) at 230VAC
LEAKAGE CURRENT0.25mA/240VAC
PROTECTIONOVERLOAD110% ~ 150% rated output power
Protection type: Hiccup mode, recovers automatically after fault condition is removed
OVER VOLTAGE41.4 ~ 48.6V
Protection type: Shut off o/p voltage, re-power on to recover
ENVIRONMENTWORKING TEMP.-30 ~ +65°C (Refer to “Derating Curve”)
WORKING HUMIDITY20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY-40 ~ +80°C, 10 ~ 95%RH
TEMP. COEFFICIENT±0.03%/°C (0 ~ 50°C)
VIBRATION10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC SAFETY STANDARDSUL1310 class 2, CAN/CSA No. 223-M91, IP67 approved ; design refer to TUV EN60950-1
WITHSTAND VOLTAGEI/P-O/P:3KVAC
ISOLATION RESISTANCEI/P-O/P:>100M Ohms/ 500VDC / 25°C / 70% RH
EMC EMISSIONCompliance to EN55032 (CISPR32) Class B, EN61000-3-2 Class A, EN61000-3-3
EMC IMMUNITYCompliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
NOTE1. All parameters NOT specially mentioned are measured at 230VAC input,rated load and 25°C of ambient temperature.2. Ripple & noise are measured at 20MHz of bandwidth by using a 12’’ twisted pair-wire terminated with a 0.1μf & 47μf parallel capacitor.3. Tolerance: includes set up tolerance, line regulation and load regulation.4. Derating may be needed under low input voltage. Please check the static characteristics for more details.5. The power supply is considered a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-quality EMC Directive on the complete installation again.6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.8. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minutes.

QUESTIONS & ANSWERS

Copyright 2018 @ Sure Electronics Co., Ltd.

Confirm